Activmotion S


The Activmotion S range is intended for knee osteotomy in adults.                                                                                                                                      Activmotion S brochure


Knee alignment is our philosophy. 


The most complete range of plates for knee osteotomy

• Closing and opening tibial and femoral plates

• Dedicated plates for HTO+ACL reconstruction

• Several sizes because one plate cannot fit all!


Anteromedial positioning of the HTO plates 

• To be as close as possible to the lateral stress

• Limiting the tibial internal rotation of the distal fragment and preserving the lateral hinge

• Limiting the lever harm of the screws 


Small implants with great stability

• Small implants to limit patient pain

• Titanium alloy (TAGV) implants for optimized mechanical resistance

Activmotion S - full range - feb 2021

Opening wedge High Tibial Osteotomy plates 


Technical features

  • Anatomic asymmetrical implants (blue anodized for left plates and green anodized for right plates).
  • Antero-medial positioning to be as close as possible to the lateral stress.
  • The design of the size 2 implant is adapted to large biplanar cuts or large osteotomies.
  • Titanium alloy TA6V implants for optimized mechanical resistance.


Size 1

For monoplanar osteotomies

  • Up to 12 mm of correction


Size 2

For biplanar osteotomies

  • Ascendant osteotomies
  • Over 12 mm of correction
opening wedge high tibial osteotomy plates size 1 & 2


Opening wedge High Tibial Osteotomy with ACL replacement plates



  • Anatomic asymmetrical implants (blue anodized for left plates and green anodized for right plates).
  • To prevent any risk of damaging the tunnel, the plate’s upper part is optimized for ACL reconstruction.
  • 1 polyaxial locking hole located in the proximal part of the ACL tunnel to avoid damaging the graft.
  • One design compatible with the peek or titanium endobutton placement.
opening wedge hogh tibial osteo with ACL replacement

Distal Femoral Osteotomy plates


Technical features


  • Medial closing and lateral opening plates.
  • Anatomic asymmetrical implants (green anodized for right plates and blue anodized for left plates).
  • 2 offset screw holes improving the mechanical features of the assembly and preventing loss of angular correction:

- On both sides of the osteotomy site for closing;

- Above the osteotomy site for opening.


  • Monoaxial locking screws (Oneclip®):

- 7 screws for the closing plate;

- 8 screws for the opening plate.


  • 1 polyaxial locking screw (DTS) allowing to avoid the intercondylar notch, if necessary. Possible angulation of the screw before locking (25° locking range) thanks to the DTS system.
  • 1 ramp oblong hole allowing for a simple and controlled compression for closing.
distal femoral osteo plates

Closing wedge High Tibial Osteotomy plates 


Technical Features


  • Lateral and medial closing plates (2 sizes available)
  • Precontourned implants: the design of these plates is the result of a proprietary state-of-the-art mapping technology to establish the maximum congruence between the plate and the bone
  • Compression oblong ramp hole to optimize the osteotomy compression
  • Size 1 plates compatible with mini invasive approach
  • Titanium alloy TA6V implants for optimized mechanical resistance
  • Medial plate: antero-medial positioning for an easier positioning of the plate avoiding the medial step due to the osteotomy


Varisation plates

Activmotion S - variation plates - feb 2021

Valgisation plates

Valgisation plates - Activmotion S

Return Top